[EN] Error messages when rebooting after installation

[marinecomm]

Installation went fine but when I rebooted and try to boot from harddisk it keeps looping the same two error messages:


Could not read microcode


Could not read iwlwifi


The only way I have found to stop this is to do a hard reboot. Has anyone experienced this issue before?

[devil]

No, you need to tell us about your hardware first. The command

Code: [Select]

inxi -v3 will give us the needed information. Besides that you need to check the md5-sum of your iso image.


greetz
devil

[bluelupo]

Installation went fine but when I rebooted and try to boot from harddisk it keeps looping the same two error messages:

Could not read microcode

Could not read iwlwifi

The only way I have found to stop this is to do a hard reboot. Has anyone experienced this issue before?

Hi,
do you have installed the package firmware-iwlwifi?