Siduction Forum > Hardware - Support

 eth0 changes from 1000 to 100Mbit

<< < (2/2)

absolut:
some more insights from today below... i think more and more towards the Ethernet cable. need to find a replacement and check it after that


--- Code: ---root@sidbox:[/home/absolut]# dmesg | grep eth
[    0.939314] e1000e 0000:00:19.0 eth0: (PCI Express:2.5GT/s:Width x1) d0:50:99:73:d0:74
[    0.939317] e1000e 0000:00:19.0 eth0: Intel(R) PRO/1000 Network Connection
[    0.939349] e1000e 0000:00:19.0 eth0: MAC: 11, PHY: 12, PBA No: FFFFFF-0FF
[    4.083717] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[    4.300173] IPv6: ADDRCONF(NETDEV_UP): eth0: link is not ready
[    7.178634] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
[    7.178678] IPv6: ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
[   12.083049] e1000e: eth0 NIC Link is Up 100 Mbps Half Duplex, Flow Control: None
[   12.083058] e1000e 0000:00:19.0 eth0: 10/100 speed: disabling TSO
[  311.104061] e1000e: eth0 NIC Link is Down
[  318.134169] e1000e: eth0 NIC Link is Up 100 Mbps Half Duplex, Flow Control: None
[  318.134172] e1000e 0000:00:19.0 eth0: 10/100 speed: disabling TSO
[  400.763223] e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
--- End code ---

DeepDayze:
Best cable for ensuring you get reliable 1000Mbit network speeds are Cat 5e cables, where as the older cat 5 (with no e) just barely support that speed reliably. Also make sure you are using quality made cables and that are not damaged. Hope this helps.

Navigation

[0] Message Index

[*] Previous page