BUGS > 2021.2 Farewell

 Lang. + keyb. settings during live and after install do not match. Password lost

(1/1)

Crypto:
Hi,

I have successfully installed KDE iso here. I am currently happy with few minor things that could be sorted out:

(1) When live mode starts, select "de" both for language and keyboard.
(2I When live mode is ongoing, run installer.
Bug: Installer starts from language English + timezone US. It should still use "de" + Europe for timezone.

Another issue:
(1) After siduction is installed on harddrive, complete all settings, do all d-u.
(2) Wait until screen locks and you need to enter user password to exit screen lock.
Bug: Although during installation passwords both for user and admin were given, this user pw is now invalid and does not exit screen lock screen (I then did a reset). You have to enter system settings -> user settings and assign a (new?) valid password.

Crypto.

towo:

--- Quote ---(2I When live mode is ongoing, run installer.
Bug: Installer starts from language English + timezone US. It should still use "de" + Europe for timezone.
--- End quote ---

Installer is using geoip location for the 1st setting.


--- Quote ---Another issue:
(1) After siduction is installed on harddrive, complete all settings, do all d-u.
(2) Wait until screen locks and you need to enter user password to exit screen lock.
Bug: Although during installation passwords both for user and admin were given, this user pw is now invalid and does not exit screen lock screen (I then did a reset). You have to enter system settings -> user settings and assign a (new?) valid password.
--- End quote ---

I have 3 installs done with the KDE Image, never seen that problem.

der_bud:
There was some similar observation once >here<, but not solved and nor really clear what was happening and what the user did.
After installation completed, you did a clean reboor from hard disk and logged in with username and password, then the screenlock thing happened? Or did you set the user to autologin during installation?

Crypto:

--- Quote from: der_bud on 2021/10/25, 19:25:04 ---After installation completed, you did a clean reboor from hard disk and logged in with username and password, then the screenlock thing happened? Or did you set the user to autologin during installation?

--- End quote ---

After installation on harddisk (after pop up is shown that installation was completed) I shut down computer and did a clean reboot from harddisk.
During install I have selected to auto log in without asking for password.
So computer boots up OK and I do not have to enter password. I can do network settings to connect to WLAN and do d-u.

I left computer unattended and lock screen was shown after auto timeout so password was required to unlock computer, but my password that I entered for user during install did not work. I had to reset computer and reboot. Then I checked system settings and for user I re-entered my password (not sure if it was known to system before at all as old password was not displayed). Then lock screen could be left OK with entering my password, as expected.

Crypto.

der_bud:
Perhaps "autologin" could be the point here, I myself never used that (and AFAIK most of the siduction team neither). When I have time I try to replicate your setup....

Navigation

[0] Message Index