Siduction Forum > Hardware - Support

[EN] New Board, no spdif and network not working properly (r8169)

<< < (2/2)

Lanzi:
Hi Bud,it's what networkmanager shows me, but your command shows the same output.


--- Code: ---ethtool enp4s0

Settings for enp4s0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
                                2500baseX/Full
        Supported pause frame use: Symmetric Receive-only
        Supports auto-negotiation: Yes
        Supported FEC modes: Not reported
        Advertised link modes:  Not reported
        Advertised pause frame use: No
        Advertised auto-negotiation: No
        Advertised FEC modes: Not reported
        Speed: 100Mb/s
        Duplex: Full
        Auto-negotiation: off
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        MDI-X: Unknown
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
                               drv probe ifdown ifup
        Link detected: yes
--- End code ---
and coping files to my server is really slow.
My fritzbox-router has the setting 1Gbit for all 4 Lan-Channels, so that there is no problem.

Lanzi:
I found the setting in Networkmanager. "Link negotiantion" ("Automatisches Aushandeln zulassen"). It was deactivated, maybe because of the former driver. So, I activated it and everything seems good now.
Thanks to all helpers.

Navigation

[0] Message Index

[*] Previous page