Siduction Forum
Siduction Forum => Installation - Support => Topic started by: marinecomm on 2014/11/26, 03:49:16
-
Installation went fine but when I rebooted and try to boot from harddisk it keeps looping the same two error messages:
Could not read microcode
Could not read iwlwifi
The only way I have found to stop this is to do a hard reboot. Has anyone experienced this issue before?
-
No, you need to tell us about your hardware first. The command
inxi -v3
will give us the needed information. Besides that you need to check the md5-sum of your iso image.
greetz
devil
-
Installation went fine but when I rebooted and try to boot from harddisk it keeps looping the same two error messages:
Could not read microcode
Could not read iwlwifi
The only way I have found to stop this is to do a hard reboot. Has anyone experienced this issue before?
Hi,
do you have installed the package firmware-iwlwifi?